Haws 9327 User Manual download pdf (Page 5)

1) MOUNTING THE HEATER TO THE WALL

Please follow the mounting instructions as appropriate to your installation. Whenever possible, locate the

heater as close to the point of hot water use as possible. Time-to-temperature performance will improve

the closer the heater is installed to the point of use.

Make sure the brass fittings are at the bottom of the

heater and pointing “DOWN”. No other heater

orientation is permitted.

Install the heater with cabinet using the supplied

mounting feet following the instructions provided with

the cabinet. Be sure to use appropriately rated fasteners

to hold the cabinet/heater in place.

2) PLUMBING HOOK-UP

The heater is equipped with NPT brass fittings. Make

sure ONLY NPT fittings are used for connection to this

heater.

Make the cold water inlet connection to the lower RIGHT

fitting and the hot water outlet connection to the lower

LEFT fitting. Reversed connections will cause erratic

operation and premature heater failure.

NEVER USE PIPE DOPE WHEN MAKING PLUMBING CONNECTIONS TO THIS HEATER.

FOLLOW STANDARD INDUSTRY PRACTICE WITH CAREFUL APPLICATION OF TEFLON

TAPE. DO NOT ALLOW TEFLON TAPE TO GET INTO THE HEATER.

NEVER SOLDER ANY PIPE CONNECTIONS WHILE ATTACHED TO THIS HEATER - DAMAGE

TO THE HEATER WILL RESULT. DOING THIS WILL VOID THE WARRANTY.

COLD

WATER

HOT

WATER

OUT

This heater must be installed in a location where

it is not subject to freezing temperatures.**

** Does not apply to SafeAdvantage with

Freeze Protection option.

01/14

9326/9327

Page 5 of 12

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Haws 9327 User Manual Page 5