Haws 8309 User Manual download pdf (Page 3)

04/14 Model 8300-8309/8300CRP-8309CRP Page 3 of 5

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1. No flow. 1. Check the main shut-off valve.

2. Water leak between joints or fittings. 2. Tighten loose connections. If leak

persists, the application of hot water

will sometimes reseat improperly

applied joint compound. After 30

minutes wait and retest. A persistent

leak will necessitate reassembly and

additional sealant.

3. Insufficient water flow, shower and

eyewash.

3. Verify minimum 30 psi (2 ATM) flowing

supply line pressure.

4. Water does not drain properly. 4. Check your drain system for debris.

Check the main waste line of your

building to see if it does handle the

capacity required for the entire

drainage system.

5. Insufficient water flow on eyewash,

however, shower is sufficient.

5.a.

Verify minimum 30 psi (2 ATM) flowing

supply line pressure.

b. Probable clogging of flow control due

to inadequate line flushing. Unscrew

eye/face wash head and remove the

four screws to disassemble head.

Clean flow control and reassemble

head. See SP65 Installation Drawing

for details.

c. Remove cap located on L – Strainer

using a 3/8” allen wrench to access

and clean filter screen.

6. Eyewash or face wash streams do not

meet at desired eye level or are not

balanced.

6. Possible blocked flow control see

above solution. (Possible non-leveled

eyewash assembly.)

7. Insufficient water flow at the

showerhead, however, eyewash is

sufficient.

7.a. Probable clogging of flow control inside

shower head. Unscrew shower head

off of elbow and clean rubber flow

control.

HAWS® and other trademarks used in these materials are the exclusive property of Haws Corporation.

1 2 3 4 5

Comments to this Manuals

No comments

Haws 8309 User Manual Page 3

Comments to this Manuals

Related products and manuals for Safety Haws 8309